Use Run Time to set up a summary view for the total amount of time system equipment is running or down, as represented by a specific data point. Summary view can also be used to categorize the amount of time equipment is down due to mechanical or operational reasons. Total downtime is calculated as a percentage of total Run Time.
Run Time set up applies only to enabled digital data points. The website calculates Run Time totals in days, hours, minutes, and seconds based on a date range you specify during setup. For example, a total time of 7 13:41:26 refers to 7 days, 13 hours, 41 minutes, and 26 seconds.
The procedures below explain how to:
To set up a new run time view
- Click All Units in Unit System Status.
- Select a unit in the Unit column to display Unit Detail.
- Click the Run Time tab in Unit Detail.
- Click the add icon (+) to set up a new run time view.
- Type a name in the View Name field that identifies the new run time view.
- Click the arrow in Default Date Range and choose a date range for run time data you want to view.
- Click Show Duplicates if you want to view run time data that has been hidden using filter options.
- Click State Data Point and select the digital data point used to monitor equipment run time.
- If you want to include run time data for additional data points, select one or more data points in Additional Data to Display.
- Click Save to save changes or the close icon (X) to cancel changes and close Run-Time View.
To edit an existing run time view ˆtop of pageˆ
- Click All Units in Unit System Status.
- Select a unit in the Unit column to display Unit Detail.
- Click the Run Time tab.
- Click the down arrow in the View field and select a run time view.
- Click the edit view icon (pencil) and change settings as needed.
- Click Save to save changes or the close icon (X) to cancel changes and close Run-Time View.
To filter data in run time view ˆtop of pageˆ
- Click All Units in Unit System Status.
- Select a unit in the Unit column to display Unit Detail.
- Click the Run Time tab.
- Click the down arrow in the View field and select a run time view.
- Click the edit icon (pencil) associated with a run time entry to display available filters.
- Review the following information and then select one or more filters as needed:
- Is Mech: select this filter when equipment downtime is due to mechanical reasons.
- Is Op: select this filter when equipment downtime is due to operational reasons.
- Duplicates: select this filter to exclude up or down time in total run time calculations. This filter also hides data in run time view. To display data, click Show Duplicates.
- Click the update icon (diskette) to save changes or the cancel icon (X) to cancel changes and close the filter window.